Operation CHARM: Car repair manuals for everyone.

Removal and Replacement




BCM: Removal and Installation

Removal

NOTE:

If possible, before removing BCM, retrieve current BCM configuration to use for reference when configuring brand-new BCM after installation. Refer to [Additional Service When Replacing Control Unit (BCM)] Procedures.

1) Disconnect the battery negative terminal.
2) Remove the instrument lower panel LH. Refer to [Instrument Lower Panel LH: Removal and Installation] Instrument Lower Panel LH.
3) Remove the BCM screws and release the BCM.





4) Disconnect the BCM connectors and then remove the BCM.

Installation

Installation is in the reverse order of removal.

- When replacing the BCM, it must be configured. Refer to [Body Control System: Configuration (BCM)] Testing and Inspection.
- When replacing the BCM, if equipped with immobilizer system perform initialization of immobilizer system and registration of all immobilizer system ignition key IDs. Refer to [Body Control System: Configuration (BCM)] Testing and Inspection.
- When replacing the BCM, perform ID registration procedure of low tire pressure warning system. Refer to [ID Registration Procedure] Programming and Relearning.
- When replacing the BCM, if equipped with remote keyless entry, register the remote keyless entry system keyfob ID codes. Refer to [Additional Service When Replacing Control Unit (BCM)] Procedures.
- When replacing the BCM, perform adjustment procedure for the steering angle sensor if equipped. Refer to [Adjustment of Steering Angle Sensor Neutral Position] Adjustments (type 2) or [Adjustment of Steering Angle Sensor Neutral Position] Adjustments (type 3).