Self-Diagnosis Function (without SDT)

Self-Diagnosis Function (without SDT)

- The reading of these results is accomplished using one of two modes -"User mode" and "Diagnosis mode".
- After a malfunction is repaired, turn the ignition switch OFF for at least one second, then back ON. Diagnosis mode returns to the User mode. At that time, the self-diagnostic result is cleared.

How to Change Self-Diagnosis Mode





Diagnostic Procedure 3

Final Check of SRS Using SDT-Diagnosis Mode

1) Connect SDT.
2) If no DTC is detected on "DTC check", repair of SRS is completed. Go to step 3.

If any DTC is detected on "DTC check", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Perform DIAGNOSTIC PROCEDURE 2. Refer to [SRS Operation Check] SRS Operation Check.
3) Touch "Clear".

NOTE:
Touch "Clear" to clear the memory of the malfunction ("DTC check [PAST]").

If the memory of the malfunction in "DTC check [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.

4) Touch "BACK" key of SDT. Touch "DTC check".
5) Check that no malfunction is detected on "DTC check".
6) Touch "BACK" key of SDT to return to User mode from Diagnosis mode.
7) Turn ignition switch OFF and then turn off and disconnect SDT.
8) Go to [SRS Operation Check] SRS Operation Check.

Diagnostic Procedure 4

Check SRS Repair History

1. CONSIDER POSSIBILITY THAT SELF-DIAGNOSTIC RESULT WAS NOT ERASED AFTER REPAIR

Check repair history of the SRS.

Have any previous repairs been made to the SRS?
YES
"DTC check" result (previously stored in the memory) might not be erased after repair. Perform DIAGNOSTIC PROCEDURE 3. Refer to "Self-Diagnosis Function (Without SDT)".
NO
Perform DIAGNOSTIC PROCEDURE 2. Refer to [SRS Operation Check] SRS Operation Check.