Operation CHARM: Car repair manuals for everyone.

Side and Rollover Collision Diagnosis




Collision Diagnosis: For Side and Rollover Collision

For Side and Rollover Collision: When SRS is Activated in A Collision

CAUTION:

Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles.

WORK PROCEDURE

1 Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed.
2 Replace the following components:

- Front seat back assembly (on the side on which side air bag is activated).
- Door finisher (on the side on which door-mounted curtain air bag is activated).
- Pop-up roll bar assemblies and pop-up roll bar covers.
- Side air bag (satellite) sensor LH/RH (on the side on which side air bag is activated).
- Diagnosis sensor unit.
- Seat belt pre-tensioner assemblies.

1 Check the SRS components and the related parts using the following table.
Replace any SRS components and the related parts showing visible signs of damage (dents, cracks, deformation, etc.).
2 Perform self-diagnosis ("DTC check") using SDT and "AIR BAG" warning lamp. Refer to [SRS Operation Check] SRS Operation Check for details. Make sure entire SRS operates properly.
3 After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to [Trouble Diagnosis without SDT] Reading and Clearing Diagnostic Trouble Codes.

SRS Inspection (For Side and Rollover Collision)






For Side and Rollover Collision: When SRS is Not Activated in A Collision

CAUTION:

Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles.

WORK PROCEDURE

1 Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed.
2 Check the SRS components and the related parts using the following table.

- If the front seat back assembly is damaged, the front seat back assembly must be replaced.
- If the door finisher assembly is damaged, the door finisher assembly and door-mounted curtain air bag module must be replaced.

1 Perform self-diagnosis ("DTC check") using SDT and "AIR BAG" warning lamp. Refer to [SRS Operation Check] SRS Operation Check for details. Make sure entire SRS operates properly.
2 After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to [Trouble Diagnosis without SDT] Reading and Clearing Diagnostic Trouble Codes.

SRS Inspection (For Side and Rollover Collision)