P0010

DTC P0010

DTC Detecting Condition and Trouble Area






Wiring Diagram










DTC Confirmation Procedure

1) Start engine and warm up to normal operating temperature.
2) Run engine at idle speed for 5 min.

DTC Troubleshooting

1.
Was "Engine and Emission Control System Check" performed?
YES -
Go to Step 2.
NO -
Go to Engine and Emission Control System Check Engine and Emission Control System Check.

2. OCV drive circuit and OCV ground circuit check

Turn OFF ignition switch and disconnect connectors from ECM and OCV.
Check for proper terminal connection to ECM connectors and OCV connector.
If connections are OK, check that OCV drive circuit (A1) and OCV ground circuit (B1) are as follows.
- Wiring harness resistance of OCV drive circuit and OCV ground circuit is less than 3 ohms.
- Insulation resistance between OCV drive circuit and vehicle body ground is infinity
- Insulation resistance of wire harness is infinity between OCV drive circuit terminal and each terminal at OCV connector.
- Circuit voltage of OCV drive circuit and OCV ground circuit is 0 - 1 V with ignition switch in ON position.

Are they in good condition?
YES -
Go to Step 3.
NO -
Repair or replace defective wire harness.

3. OCV check

Check OCV. OCV (Oil Control Valve) Inspection

Is it in good condition?
YES -
Substitute a known-good ECM and recheck.
NO -
Replace OCV.