P2135

DTC P2135

DTC Detecting Condition and Trouble Area






Wiring Diagram

Refer to P0122 DTC P0122 / P0123.

DTC Confirmation Procedure

1) Turn ignition switch to ON position.
2) Keep accelerator pedal at fully depressed position for 2 sec.
3) Keep accelerator pedal at release position for 2 sec.
4) Repeat Step 2) through 3) for 3 times.

DTC Troubleshooting

1.
Was "Engine and Emission Control System Check" performed?
YES -
Go to Step 2.
NO -
Go to Engine and Emission Control System Check Engine and Emission Control System Check.

2. DTC check

Check DTC.

Is there DTC(s) other than P2135?
YES -
Go to applicable DTC(s).
NO -
Go to Step 3.

3. Wire harness check

Check TP sensor (main and sub) circuit as follows.
- TP sensor (main) circuit: Refer to Step 2 through 5 of P0122 DTC P0122 / P0123.
- TP sensor (sub) circuit: Refer to Step 2 through 5 of P0222 DTC P0222 / P0223.

Is it in good condition?
YES -
Go to Step 4.
NO -
Repair or replace defective wire harness.

4. TP sensor check

Check TP sensor for performance referring to "Throttle Position (TP) Sensor Performance Check" under Testing and Inspection Throttle Body Assembly On-Vehicle Inspection.

Is it in good condition?
YES -
Substitute a known-good ECM and recheck.
NO -
Replace throttle body assembly.