Contact Coil Cable Assembly Removal and Installation
Contact Coil Cable Assembly Removal and Installation
Steering Wheel and Column Construction
Removal
1) Remove steering wheel from steering column. Refer to Service and Repair Steering Wheel Removal and Installation.
2) Remove steering column hole cover (1).
3) Remove steering column cover screws (1) (3 pieces).
4) Separate upper cover (2) and lower cover (3), then remove them.
5) Disconnect all connectors for contact coil cable assembly.
6) Remove contact coil cable assembly (1) with steering angle sensor (if equipped) from steering column.
7) Separate steering angle sensor from contact coil cable assembly referring to Steering Angle Sensor Removal and Installation Steering Angle Sensor Removal and Installation.
Installation
Contact Coil Cable Assembly Inspection
Centering Contact Coil Cable Assembly
1) Check to make sure that vehicle's front tires are set at straight-ahead position and then ignition switch is at "LOCK" position.
2) (ESP(R) model)
Install steering angle sensor to contact coil cable assembly refer to Steering Angle Sensor Removal and Installation Steering Angle Sensor Removal and Installation.
3) Install contact coil cable assembly to steering column nothing the following.
- Fit lower fitting part first and then fit upper fitting part.
NOTE:
New contact coil cable assembly is supplied with contact coil set and held at its neutral position with a lock pin (1). Remove this lock pin after installing contact coil cable assembly to steering column.
4) Connect all connectors that have been removed in "Removal".
5) Install steering column upper cover (2) and lower cover (3), and then tighten steering column cover screws (1).
NOTE:
Lead wires will be damaged if they get pinched when you install the covers.
Make sure that there are no wires caught between the covers before securing the covers.
6) Install steering column hole cover (1).
7) Install steering wheel to steering column. Refer to Service and Repair Steering Wheel Removal and Installation.