P0712
DTC P0712: Transmission Fluid Temperature Sensor "A" Circuit Low
Wiring Diagram
DTC Detecting Condition and Trouble Area
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch OFF.
2) Clear DTCs in TCM and ECM memories by using scan tool.
3) Start engine.
4) Keep engine running at idle speed for 1 minute or more.
5) Turn ignition switch OFF.
6) Repeat Step 3) to 5) one time.
7) Check DTC, pending DTC and freeze-frame data.
DTC Troubleshooting
1.
Was "A/T System Check" performed?
YES -
Go to Step 2.
NO -
Go to A/T System Check A/T System Check.
2. Check transmission fluid temperature sensor circuit for ground short
Turn ignition switch OFF.
Disconnect TCM connectors from TCM.
Check for proper connection to transmission fluid temperature sensor at terminal "E92-11" and "E92-12".
If OK, check continuity between terminal "E92-11" of disconnected harness side TCM connector and ground.
Is continuity indicated?
YES -
Transmission fluid temperature sensor circuit is shorted to ground. If circuit is OK, go to Step 3.
NO -
Go to Step 3.
3. Check transmission fluid temperature sensor
Check transmission fluid temperature sensor referring to Transmission Fluid Temperature Sensor Inspection Transmission Fluid Temperature Sensor Inspection.
Is result satisfactory?
YES -
Intermittent trouble or faulty TCM. Check for intermittent trouble referring to Intermittent and Poor Connection Inspection Intermittent and Poor Connection Inspection. If OK, substitute a known-good TCM and recheck.
NO -
Replace solenoid wire harness including transmission fluid temperature sensor referring to Transmission Fluid Temperature Sensor Removal and Installation Transmission Fluid Temperature Sensor Removal and Installation.