P0705

WIRING DIAGRAM





CIRCUIT DESCRIPTION
Being linked with the selector lever, this switch changes selector lever positions into electric signals and send them to the transmission control module. The contact points of this switch for P and N ranges are also connected with the starting motor circuit. Also, as its contact point for R range is connected with the back up light circuit, only when the selector lever is shifted to R range, the contact point contacts to light the back up light.





DETECTING CONDITION AND POSSIBLE CAUSE

DTC CONFIRMATION PROCEDURE

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.

1. Turn ignition switch OFF.
2. Clear DTC stored in TCM and ECM.
3. Start engine and run it at idle.
4. Shift selector lever to "D" range and hold it there for longer than 10 sec.
5. Check DTC and if no malfunction DTC appears, proceed to the next step.
6. Drive vehicle at 40 mph, 60 km/h or more for longer than 30 sec.
7. Stop vehicle and then turn ignition switch OFF.
8. Repeat above step 6.
9. Stop vehicle and check DTC.

��:

INSPECTION