P0335

DTC P0335 CRANKSHAFT POSITION (CKP) SENSOR CIRCUIT MALFUNCTION





WIRING DIAGRAM





DETECTING CONDITION





Reference
Connect oscilloscope between terminals C22-3 (+) and C22-11 (-) of ECM connector connected to ECM and check CKP sensor signal.

DTC CONFIRMATION PROCEDURE
1) Clear DTC and crank engine for 2 sec.
2) Select "DTC" mode on scan tool and check DTC.

Testing Procedure:

Fig. 1:

Fig. 2:

INSPECTION

NOTE: If starter circuit is open (i.e., start signal circuit is OK but starter fails to run), this DTC is stored in memory at starter switch ON, even though CKP sensor is in good condition.
When starter motor tails to run and this DTC appears, check starter circuit first.