P0500

Wiring Diagram:

Detecting Condition / Possible Cause:

CIRCUIT DESCRIPTION - Refer to VSS operation.

DTC CONFIRMATION PROCEDURE

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.

1. Turn ignition switch OFF and then ON.
2. Clear DTC and warm up engine to normal operating temperature.
3. Increase vehicle speed to 50 mph, 80 km/h in "2" range.
4. Release accelerator pedal and with engine brake applied, keep vehicle coasting (fuel cut condition) for 4 sec. or more.
5. Stop vehicle and check DTC and pending DTC.

Inspection (Steps 1 - 3):