Manual Road Test

MANUAL ROAD TEST
This test checks the gears being used in "L", "2" or "D" range when driven with unoperated gear shift control system. Test drive vehicle on a level road.





1. With selector lever in "P" range, start engine and warm it up.
2. After warming up engine, disconnect coupler of solenoid valve wire as shown in figure.
3. With selector lever in "L" range, start vehicle and accelerate to 30 km/h (19 mile/h). Check in this state that 1st gear is being used.
4. At 30 km/h (19 mile/h), shift selector lever to "2" range and accelerate to 60 km/h (37 mile/h).
Check in this state that 2nd gear is being used.
5. At 60 km/h (37 mile/h), shift selector lever to "D" range and check that 3rd gear is used when speed is higher than 60 km/h (37 mile/h).
6. After above checks, stop vehicle then engine, and connect solenoid valve wire coupler.
7. Clear DTC with scan tool.