P0335

WIRING DIAGRAM

Detecting Condition / Trouble Area:

DTC DETECTING CONDITION AND TROUBLE AREA

DTC CONFIRMATION PROCEDURE

NOTE: Check to make sure that the following conditions are satisfied when using this DTC CONFIRMATION PROCEDURE.
- Intake air temp.: -14 °C, 6.8 °F or higher
- Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)

1. With ignition switch OFF, connect scan tool.
2. Turn ON ignition switch and clear DTC using scan tool.
3. Start engine and run it for 10 sec.
4. Check DTC and pending DTC.

Step 1 - 4:

TROUBLESHOOTING




REFERENCE
Connect oscilloscope between E91-9 and E91-19 terminals of ECM connector connected to ECM and check CKP sensor signal.