P0125
DTC P0125: Insufficient Coolant Temperature for Closed Loop Fuel ControlWiring Diagram:
Wiring Diagram
DTC Detecting Condition:
DTC Detecting Condition and Trouble Area
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and tester, on a level road.DTC Confirmation Procedure
NOTE: Check to make sure that the following conditions are satisfied when using this DTC Confirmation Procedure .
- Intake air temp.: 14 °C, 6.8 °F or higher
- Altitude (barometric pressure): 2020 m, 6650 ft or less (540 mmHg, 72 kPa or more)
1. With ignition switch turned OFF, connect scan tool.
2. Turn ON ignition switch and clear DTC using scan tool.
3. Start engine and drive vehicle at 40 mph (60 km/h) or higher for 20 min. or more.
4. Check DTC and pending DTC.
Step 1 - 4:
Step 4 Continued - 10:
DTC Troubleshooting