P1107

DTC P1107: Manifold Absolute Pressure (MAP) Sensor Rationality - Low





Wiring Diagram





DTC Detecting Condition and Trouble Area

DTC Confirmation Procedure

WARNING:

- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.

- Road test should be carried out with 2 persons, a driver and a tester, on a level road.

NOTE:

Check to make sure that the following condition is satisfied when using this "DTC Confirmation Procedure".

- Intake air temp.: -10°C, 14°F or higher

- Altitude (barometric pressure): 2500 m, 8202 ft or less (560 mmHg, 75 kPa or more)

1) Connect scan tool to DLC with ignition switch OFF.

2) Turn ON ignition switch and clear DTC using scan tool and warm up engine completely.

3) Drive vehicle at 30 mph, 50 km/h or more for 10 mm. or more.

4) Release accelerator pedal and with engine brake applied, keep vehicle coasting and stop vehicle.

5) Run engine at idle speed for 1 mm.

6) Check DTC and pending DTC.

















DTC Troubleshooting