P0455

DTC P0455: Evaporative (EVAP) Emission System Large Leak Detected

Circuit Description
The Evaporative (EVAP) emission system includes the following components:
- Fuel tank
- EVAP emission vent solenoid
- Fuel tank pressure sensor
- Fuel pipes and hoses
- Fuel vapor lines
- Fuel cap
- EVAP emission canister
- Purge lines
- EVAP emission canister purge valve
- EVAP emission service port

The EVAP emission system is checked by applying vacuum to the EVAP emission system and monitoring for a vacuum decay. The Engine Control Module (ECM) monitors the vacuum level through the fuel tank pressure sensor signal. At the appropriate time, the EVAP emission canister purge valve and the EVAP emission vent solenoid are turned ON, allowing the engine to draw a small vacuum on the entire evaporative emission system. After the desired vacuum level has been achieved, the EVAP emission canister purge valve is turned OFF, sealing the system. A leak is detected by monitoring for a decrease in the vacuum level over a given time period, when all other variables remain constant. A small leak in the system will cause DTC P0455 to be set.

Conditions for Setting the DTC
Fuel tank pressure difference during evacuation is between -13.1 and -7.5 kPa.

Action Taken When the DTC Sets
- The Malfunction Indicator Lamp (MIL) will illuminate.
- The ECM will record operating conditions at the time the diagnostic fails. This information will be stored in the Freeze Frame and Failure Records buffers.
- A history DTC is stored.

Conditions for Clearing the MIL/DTC
- The MIL will turn OFF at the end of 3 consecutive ignition cycles in which the diagnostic runs without a fault.
- A history DTC will clear after 40 consecutive warm up cycles without a fault.
- DTC(s) can be cleared by using the scan tool.

Diagnostic Aids
Check for the following conditions:
1. Missing or damaged O-ring at fuel vapor and EVAP emission purge line canister fittings.
2. Cracked or punctured EVAP emission canister.
3. Damaged source vacuum line, EVAP emission purge line, EVAP emission vent hose or fuel tank vapor line.
4. Poor connection at ECM. Inspect harness connectors for the following conditions:
- Backed-out terminals
- Improper mating
- Broken locks
- Improperly formed
- Damaged terminals
- Poor terminals to wire connection
- Physical damage to the wiring harness

Step 1 - 7:

Step 8 - 12:

DTC Troubleshooting