P0463

DTC P0463: Fuel Level Sensor Circuit High Voltage

Wiring Diagram:

Circuit Description
The Engine Control Module (ECM) uses the fuel level input from the Fuel Level Sensor to calculate expected vapor pressures within the fuel system. Vapor pressure vary as the fuel level changes. Vapor pressure is critical in determining if the Evaporative (EVAP) emission system is operating properly. Fuel Level is also used to determine if the Fuel level is too high or too low to be able to accurately detect EVAP system faults. This Diagnostic Trouble Code (DTC) detects a stuck fuel level sender.

Conditions for Setting the DTC
- Ignition ON.
- Battery voltage is greater than 9.953 V.
- Fuel tank level signal is greater than 4.995 V.

Action Taken When the DTC Sets
- The Malfunction Indicator Lamp (MIL) will illuminate.
- The ECM will record operating conditions at the time the diagnostic fails. This information will be stored in Failure Records buffers.
- A history DTC is stored.

Conditions for Clearing the MIL/DTC
- The MIL will turn OFF at the end of 3 consecutive ignition cycles in which the diagnostic runs without a fault.
- A history DTC will clear after 40 consecutive warm up cycles without a fault.
- DTC(s) can be cleared by using the scan tool.

Diagnostic Aids
Inspect harness connectors for backed-out terminal, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal-to-wire connection. Inspect the wiring harness for damage. A stuck Fuel Level Sensor may cause the DTC to set. If DTC P0463 cannot be duplicated, the information included in the Freeze Frame data can be useful in determining vehicle operating conditions when the DTC was first set. Resistance check for the Fuel Level Sensor. Empty = 100 or over. Half full = about 32.5 . Full = 10 or less.

Step 1 - 4:

Step 5 - 12:

DTC Troubleshooting