P0700

DTC P0700: Transaxle Control Module (TCM) Requested MIL Illumination

Circuit Description
The Transaxle Control Module (TCM) and the Engine Control Module (ECM) are connected through the serial data link circuit. The TCM sends a P-code status message to the ECM every 100 milliseconds to confirm the transaxle is functioning correctly. If the TCM detects either an A- or B-type malfunction within the transaxle, the TCM will send to the ECM a P-code status message to turn the Malfunction Indicator Lamp (MIL) ON and set DTC P0700.

Conditions for Setting the DTC
- Ignition ON.
- Received message from the TCM indicating malfunction is detected in TCM.

Action Taken When the DTC Sets
- The Malfunction Indicator Lamp (MIL) will illuminate.
- The ECM will record operating conditions at the time the diagnostic fails. This information will be stored in the Freeze Frame and/or Failure Records buffers.
- A history DTC is stored.

Conditions for Clearing the MIL/DTC
- A history DTC will clear after 40 consecutive warm up cycles without a fault.
- DTC(s) can be cleared by using the scan tool.
- Disconnecting the ECM battery feed for more than 10 seconds.

Diagnostic Aids
An intermittent may be caused by a poor connection, rubbed-through wire insulation or a wire broken inside the insulation. Check for a poor connection or damaged ECM/TCM harness. Inspect the serial data link circuit for the following conditions:
- Improper mating
- Broken locks
- Improperly formed
- Damaged terminals
- Poor terminal-to-wiring connections
- Damaged harness

Step 1 - 3:

Step 4 - 5:

DTC Troubleshooting