P0500
DTC P0500: Vehicle Speed Sensor "A"Wiring Diagram
Wiring Diagram:
DTC Detecting Condition and Trouble Area
DTC Detecting Condition And Trouble Area:
DTC Confirmation Procedure
WARNING:
^ When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
^ Road test should be carried out by 2 persons, a driver and a tester.
1. With ignition switch turned OFF, connect scan tool.
2. Turn ON ignition switch and clear DTC using scan tool.
3. Warm up engine to normal operating temperature.
4. Drive vehicle at 4,000 rpm (engine speed) with 3rd gear (M/T model) or "3" range (A/T model).
5. Release accelerator pedal and with engine brake applied, keep vehicle coasting for 6 sec. or more (fuel cut condition for 5 sec. or more) and stop vehicle.
6. For A/T model, drive vehicle at more than 3,700 rpm for 10 sec.
7.Check DTC and pending DTC.
DTC Troubleshooting
NOTE: Make sure that DTC of CAN communication is not detected by ECM.
