Procedures
Select Cable Adjustment
Select Cable Removal and Installation
1) Apply parking brake and block wheels.
2) Turn ignition switch to ON position, shift select lever to "N" range.
3) Disconnect negative cable from battery.
4) Remove air cleaner assembly. Air Cleaner Assembly Removal and Installation
5) Remove console box. Diagrams
6) Remove adjuster case (cable end) from select lever pin of select lever assembly. Select Cable Components
7) Release lock plate (1) which restrict moving of lock piece (2).
8) Pull out lock piece (2) from adjuster case (3) using such as a pliers to disengage cable.
9) Check that manual select lever is in "N" range, referring to Step 5) of Transmission Range Sensor Inspection and Adjustment Transmission Range Sensor Inspection and Adjustment.
10) Apply grease to select lever pin (1), and then install adjuster case (2) into select lever pin securely.
"A" Grease: 99000-25011 (SUZUKI Super Grease A)
11) Push lock piece (3) in arrow direction [a] as shown in figure.
12) Slide lock plate (4) in arrow direction [b] as shown in figure, until it gets over the craw (5).
13) Connect negative cable to battery.
14) After installing select cable, check the following.
- Perform P Range Test "P" Range Test.
- Check back-up light is turned on when shifting select lever to "R" range.
- Check shift position indicator (in combination meter) is consistent with select lever range.
- Check engine starts at "P" and "N" ranges. And check engine does not start at other than "P" and "N" ranges.
15) Install air cleaner assembly. Air Cleaner Assembly Removal and Installation