Cruise Control Switch Inspection

Cruise Control Switch Inspection

1) Remove driver air bag (inflator) module referring to Removal and Installation Driver Air Bag (Inflator) Module Removal and Installation:Except Advanced Air Bag or Removal and Installation Driver Air Bag (Inflator) Module Removal and Installation:Advanced Air Bag.
2) Disconnect cruise control switch connector (1) from control coil.
3) Check cruise control switch as follow.

MAIN (ON/OFF) Switch

Check for continuity between "S61-6" and "S61-11" terminals under each condition below.

If check result is not satisfactory, replace cruise control switch (2).

Cruise MAIN (ON/OFF) switch (3) specification
Switch button released: Infinity
Switch button pressed: Continuity

SET/COAST, RES/ACC and CANCEL Switch

Check for resistance between "S61-10" and "S61-12" terminals under each condition below.

If check result is not satisfactory, replace cruise control switch (2).

SET/COAST, RES/ACC and CANCEL switches resistance
All switches released (OFF): Infinity
CANCEL switch (4) pressed (ON): About 0 ohms
SET/COAST switch (5) pressed (ON): 213 - 227 ohms
RES/ACC switch (6) pressed (ON): 882 - 938 ohms