Extension Housing: Service and Repair

NOTE: For removal and installation procedures refer to "Manual Transmission/Transaxle, Service and Repair."





1. If necessary, replace reverse restrict pin.
a. Remove the reverse restrict pin. Using a torx socket wrench (T40), remove the screw plug.
- Using a pin punch and hammer, drive out the slotted spring pin.
- Remove the reverse restrict pin.





b. Inspect the reverse restrict pin.
Turn and push the reverse restrict pin by hand.
Check for smooth operation.





c. Install the reverse restrict pin.
- Install the reverse restrict pin to the transfer adaptor.
- Using a pin punch and hammer, drive in the slotted spring pin, as shown.
- Apply sealant to the plug threads.

Sealant: THREE BOND 1344, LOCTITE 242 or equivalent.

- Using a torx socket wrench (T40), install and torque the screw plug.
Torque: 19 N.m (14 ft. lbs.)





2. If necessary, replace transfer adaptor oil seal.
a. Using a screwdriver, pry out the oil seal.
b. Using Special Service Tool (SST) 09950-60010 (09951-00570), 09950-70010 (09951-07150) and a hammer, drive in a new oil seal.
Drive in depth: 45.6 ± 0.5 mm (1.795 ± 0.020 inch)