Knock Sensor: Service and Repair

Components For Removal And Installation Part 1 Of 2:

Components For Removal And Installation Part 2 Of 2:

COMPONENTS FOR REMOVAL AND INSTALLATION

KNOCK SENSORS REMOVAL

1. DRAIN ENGINE COOLANT
2. REMOVE AIR CLEANER HOSE
3. REMOVE INTAKE AIR CONNECTOR
4. REMOVE HIGH-TENSION CORDS WITH IGNITION COILS
5. REMOVE FUEL PRESSURE REGULATOR
6. REMOVE INTAKE MANIFOLD ASSEMBLY
7. REMOVE WATER BYPASS PIPE AND KNOCK SENSOR WIRE





8. REMOVE KNOCK SENSORS
Using SST. remove the knock sensor. SST 09817-16011

KNOCK SENSOR INSTALLATION

1. REINSTALL KNOCK SENSORS
Using SST, install the knock sensor. SST 09817-16011

Torque: 39 N.m (400 kgf.cm. 29 ft.lbf)

2. REINSTALL WATER BYPASS PIPE AND KNOCK SENSOR WIRE
3. REINSTALL INTAKE MANIFOLD ASSEMBLY
4. REINSTALL FUEL PRESSURE REGULATOR
5. REINSTALL HIGH-TENSION CORDS WITH IGNITION COILS
6. REINSTALL INTAKE AIR CONNECTOR
7. REINSTALL AIR CLEANER HOSE
8. REFILL WITH ENGINE COOLANT
9. RECHECK ENGINE COOLANT LEVEL