Input Shaft: Service and Repair

NOTE: For removal and installation procedures refer to "Manual Transmission/Transaxle, Service and Repair."





If necessary, replace input shaft bearing.
a. Using a snap ring expander, remove the snap ring.





b. Using a press, remove the bearing.





c. Using SST 09506-35010 and a press, install a new bearing.





d. Select a snap ring that will allow minimum axial play.
Mark A: 2.10-2.15 mm (0.0827-0.0846 inch)
Mark B: 2.15-2.20 mm (0.0846-0.0866 inch)
Mark C: 2.20-2.25 mm (0.0866-0.0886 inch)
Mark D: 2.25-2.30 mm (0.0886-0.0906 inch)
Mark E: 2.30-2.35 mm (0.0906-0.0925 inch)
Mark F: 2.35-2.40 mm (0.0925-0.0945 inch)
Mark G: 2.40-2.45 mm (0.0945-0.0965 inch)
e. Using a snap ring expander, install the snap ring.