Clearing Trouble Codes

NOTE: This is the only information provided by the manufacturer for Clearing Diagnostic Trouble Codes for this system.






A. In case of not using TOYOTA hand-held tester:
Clear the DTC.
1. Using SST, connect terminals Tc and CG of DLC3.

SST 09843-18040

2. Turn the ignition switch ON.
3. Clear the DTC stored in ECU by depressing the brake pedal 8 times or more within 5 seconds.
4. Check that the warning light shows the normal code.
5. Remove the SST from the terminals of DLC3.

SST 09843-18040

HINT: Cancellation cannot be done by removing the battery cable or ECU-IG fuse.





B. In case of using TOYOTA hand-held tester:
Clear the DTC.
1. Hook up the TOYOTA hand-held tester to the DLC3.
2. Turn the ignition switch ON.
3. Operate the TOYOTA hand-held tester to erase the codes.

HINT: Please refer to the TOYOTA hand-held tester operator's manual for further details.