Clearing Trouble Codes

NOTE: This is the only information provided by the manufacturer for clearing diagnostic trouble codes for this system.

In case of not using TOYOTA hand-held tester:
Clear DTC.
1. Using SST, connect the terminals Tc and CG of the DLC3.
SST 09843-18040
2. Turn the ignition switch ON.




3. Clear DTC stored in ECU by depressing the brake pedal 8 or more times within 5 sec.
4. Check that the ABS warning light shows the normal code.
5. Remove the SST from the DLC3.

HINT: Disconnect the battery cable during repairs will not erase the DTC in the ECU.

In case of using TOYOTA hand-held tester:
Clear the DTC.
1. Turn the ignition switch ON.
2. Operate the TOYOTA hand-held tester to erase the codes.

HINT: Please refer to the TOYOTA hand-held tester operator's manual for further details.