P1349

DTC P1349 VVT SYSTEM MALFUNCTION (BANK 1)

CIRCUIT DESCRIPTION

DTC Detecting Condition:

The VVT system controls the intake camshaft to provide the optimal valve timing for every driving condition. This control is performed based on the signals, such conditions as air flow rate, throttle position and engine coolant temperature. The ECM controls the Oil Control Valve (OCV), based on the signals output from the sensors. The WT controller regulates the intake camshaft angle using oil pressure through the OCV. As result, the relative position between the camshaft and the crankshaft becomes optimal, and the engine torque improves, fuel economy improves, exhaust emissions decrease under overall driving conditions. Also, the ECM detects the actual valve timing using the signals from the camshaft position sensor and the crankshaft position sensor, and performs feedback control. This is how target valve timing is achieved by the ECM.

Wiring Diagram:

INSPECTION PROCEDURE

HINT:
- If DTC P1349 is displayed, check the VVT system circuit.
- Read freeze frame data using the hand-held tester or the OBD II scan tool, as freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, this is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the air-fuel ratio was lean or rich, etc. at the time of the malfunction.

Step 1 - 3:

Step 4 - 7:

Step 8 - 11:

Hand-held tester

Step 1 - 3:

Step 4 - 8:

Step 9 - 11:

OBD II scan tool (excluding hand-held tester)