B1793

DTC B1793 Occupant Classification Sensor Power Supply Circuit Malfunction

DESCRIPTION

DTC Detection Condition:

The occupant detection sensor power supply circuit consists of the occupant classification ECU and the occupant detection sensors.

DTC B1793 is set when a malfunction is detected in the occupant detection sensor power supply circuit.

HINT:
- When DTC B1650/32 is detected as a result of troubleshooting the airbag system, perform troubleshooting for DTC B1793 of the occupant classification system.
- Use the intelligent tester or Techstream to check for DTCs of the occupant classification ECU, otherwise the DTCs cannot be read.

Wiring Diagram:

Step 1-3:

Step 3 (Continued)-4:

Step 4 (Continued)-5:

Step 5 (Continued)-8:

Step 8 (Continued):

INSPECTION PROCEDURE

NOTE: After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

HINT:
- If troubleshooting (wire harness inspection) is difficult to perform, remove the front seat RH installation bolts to see the undersurface of the seat cushion.
- In the above case, hold the seat so that it does not fall down. Holding the seat for a long period of time may cause problems, such as seat rail deformation. Hold the seat up only for as long as necessary.