P0722

DTC P0722 Output Speed Sensor Circuit No Signal

DESCRIPTION
The speed sensor SP2 detects the rotation speed of the transmission output shaft and sends signals to the ECM. The ECM determines the vehicle speed based on these signals. An AC voltage is generated in the speed sensor SP2 coil as the parking gear mounted on the rear planetary gear assembly rotates, and this voltage is sent to the ECM. The parking gear on the rear planetary gear is used as the timing rotor for this sensor.

The gear shift point and lock-up timing are controlled by the ECM based on the signals from this vehicle speed sensor and the throttle position sensor signal.








Reference (Using an oscilloscope): Check the waveform between terminals SP2+ and SP2- of the ECM connector.





Standard: Refer to the illustration.





MONITOR DESCRIPTION
The output speed sensor SP2 monitors the output shaft speed. The ECM controls the gear shift point and the lock up timing based on the signals from the output speed sensor SP2 and throttle position sensor. If the ECM detects no signal from the output shaft speed sensor SP2 even while the vehicle is moving, it will conclude that is a malfunction of the output speed sensor SP2. The ECM will illuminate the MIL and set a DTC.

MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS





TYPICAL MALFUNCTION THRESHOLDS





COMPONENT OPERATING RANGE

Wiring Diagram:

INSPECTION PROCEDURE
1. DATA LIST

HINT: Using the intelligent tester or Techstream Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Warm up the engine.
(b) Turn the ignition switch OFF.
(c) Connect the intelligent tester or Techstream to the DLC3.
(d) Turn the ignition switch ON and push the tester switch ON.
(e) Enter the following menus:
(1) Intelligent tester - Select: DIAGNOSIS / OBD/MOBD / ECT / DATA LIST /
(2) Techstream - Select: Powertrain / Engine and ECT / Data List /
(f) Follow the instructions on the tester and read the Data List.
(1) Intelligent tester

ECT:

(2) Techstream

ECT:

HINT:
^ SPD (SP2) is always 0 while driving: Open or short in the sensor or circuit.
^ The SPD (SP2) value displayed on the tester is much lower than the actual vehicle speed: Sensor trouble, improper installation, or intermittent connection trouble of the circuit.

Step 1-2:

Step 3: