P0AF5

P310 HYBRID VEHICLE CONTROL: HYBRID CONTROL SYSTEM: P0AF4-673: Open or Short to GND in Rear Motor Inverter Temperature Sensor

DTC P0AF4-673 - Open or Short to GND in Rear Motor Inverter Temperature Sensor

DTC P0AF5-674 - Short to B+ in Rear Motor Inverter Temperature Sensor

DESCRIPTION

The MG ECU located in the inverter with converter assembly detects the temperature of the rear motor inverter using a temperature sensor built into the inverter with converter assembly. The inverter cooling system is the same as that for MG2 and MG1, and it operates independently of the engine cooling system. The characteristics of the rear motor inverter temperature sensor are the same as those of the boost converter temperature sensor P3227. The MG ECU uses signals from the rear motor inverter temperature sensor to check the effectiveness of the inverter cooling system. If necessary, the MG ECU will limit inverter output to help prevent inverter overheating. The MG ECU also detects malfunctions in the rear motor inverter temperature sensor and its wiring.






INSPECTION PROCEDURE
CAUTION:
- Before inspecting the high-voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
- After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals. After waiting for 5 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work.
HINT: Waiting for at least 5 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

PROCEDURE

1. CHECK CONNECTOR CONNECTION CONDITION (MG ECU CONNECTOR)
CAUTION: Be sure to wear insulated gloves.
(a) Turn the power switch off.
(b) Remove the service plug grip Removal.
NOTE: After removing the service plug grip, do not turn the power switch on (READY), unless instructed by the repair manual because this may cause a malfunction.
(c) Remove the inverter cover Removal.
NOTICE:
- Wrap the round interlock terminal for the inverter cover with insulating tape to prevent it from shorting to ground.
- Be sure to prevent coolant in the inverter reserve tank from entering the inverter.
- Removing the inverter cover causes the MG ECU board to be exposed. Therefore, temporarily install the inverter cover for each area to be inspected.





(d) Check the connections of the MG ECU connectors.
OK:
The connectors are connected securely and there are no contact problems.
NG -- CONNECT SECURELY
OK -- REPLACE INVERTER WITH CONVERTER ASSEMBLY