Reverse Signal Circuit

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM (w/o Navigation System): Reverse Signal Circuit

Reverse Signal Circuit

DESCRIPTION

The clock assembly receives a reverse signal from the BK/UP LP relay.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK BACK-UP LIGHT
(a) Move the shift lever to the R position and check if the back-up lights come on.
OK:
The back-up lights come on.
NG -- GO TO LIGHTING SYSTEM
OK -- Continue to next step.
2. INSPECT CLOCK ASSEMBLY





(a) Disconnect clock assembly connector E11.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE