Engine Hood Courtesy Switch Circuit

THEFT DETERRENT: THEFT DETERRENT SYSTEM: Engine Hood Courtesy Switch Circuit

Engine Hood Courtesy Switch Circuit

DESCRIPTION

The engine hood courtesy switch is built in the engine hood lock assembly. The switch turns on when the engine hood is opened and turns off when the engine hood is closed.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT ENGINE HOOD COURTESY SWITCH





(a) Remove the courtesy switch.
(b) Disconnect the E3 switch connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPLACE ENGINE HOOD COURTESY SWITCH
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK BODY ECU - ENGINE HOOD COURTESY SWITCH)





(a) Disconnect the B8 ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND)





(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE MULTIPLEX NETWORK BODY ECU