Slip Indicator Light Does Not Come ON

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: Slip Indicator Light does not Come ON

Slip Indicator Light does not Come ON

WIRING DIAGRAM

(Vehicle Stability Control System)

INSPECTION PROCEDURE

PROCEDURE

1. CHECK SLIP INDICATOR LIGHT





(a) Disconnect the skid control ECU connector.
(b) Turn the ignition switch to the ON position.
(c) Ground terminal IND of the skid control ECU.
(d) Check the SLIP indicator light.
OK:





(e) Turn the ignition switch to OFF.
(f) Reconnect the skid control ECU connector.
OK -- REPLACE MASTER CYLINDER SOLENOID
NG -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)





(a) Disconnect the skid control ECU connector.
(b) Disconnect the combination meter connector.
(c) Measure the resistance.
Standard:





(d) Reconnect the combination meter connector.
(e) Reconnect the skid control ECU connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. INSPECT COMBINATION METER ASSEMBLY
(a) Check the combination meter system (Problem Symptoms Table).
OK:
Combination meter is normal.
NG -- REPLACE COMBINATION METER ASSEMBLY
OK -- CHECK FOR INTERMITTENT PROBLEMS