P0010

2UZ-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P0010: Camshaft Position "A" Actuator Circuit (Bank 1)

DTC P0010 - Camshaft Position "A" Actuator Circuit (Bank 1)

DTC P0020 - Camshaft Position "A" Actuator Circuit (Bank 2)

DESCRIPTION

- This DTC is designed to detect opens or shorts in the camshaft oil control valve (OCV) circuit. If the OCV's duty-cycle is excessively high or low while the engine is running, the ECM will illuminate the MIL and set the DTC.
- The VVT (variable valve timing) system adjusts the intake valve timing to improve the driveability. The engine oil pressure turns the camshaft actuator to adjust the valve timing. The OCV is a solenoid valve and switches the engine oil line. The valve moves when the ECM applies the 12 V to the solenoid. The ECM changes the energizing time to the solenoid (duty-cycle) in accordance with the camshaft position, crankshaft position, throttle position, etc.









HINT: This DTC relates to the Oil Control Valve (OCV).

MONITOR DESCRIPTION

This DTC is designed to detect opens or shorts in the camshaft oil control valve (OCV) circuit. If the OCV's duty-cycle is excessively high or low while the engine is running, the ECM will illuminate the MIL and set the DTC.

MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS





TYPICAL MALFUNCTION THRESHOLDS





COMPONENT OPERATING RANGE





WIRING DIAGRAM





INSPECTION PROCEDURE

HINT: Read freeze frame data using the Techstream. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE

1. CHECK DTC
(a) Clear DTC after recording the freeze frame data and DTC (DTC Check / Clear).
(b) Turn the ignition switch off.
(c) Allow the engine to idle and check DTC.
(d) Check that P0010 or P0020 is not present.
OK:
P0010 or P0020 is not present.
NG -- INSPECT CAMSHAFT OIL CONTROL VALVE ASSEMBLY
OK -- CHECK FOR INTERMITTENT PROBLEMS
2. INSPECT CAMSHAFT OIL CONTROL VALVE ASSEMBLY





(a) Disconnect the D42 or D43 OCV connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:





NG -- REPLACE CAMSHAFT OIL CONTROL VALVE ASSEMBLY
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (OCV - ECM)





(a) Disconnect the D42 or D43 OCV connector.
(b) Disconnect the D74 ECM connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE ECM