Removal

INTERIOR: ROOF HEADLINING (for Regular Cab):

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).

2. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
(a) Remove the front seat (Removal).
3. REMOVE FRONT SEAT ASSEMBLY (for Fold Down Seat Type)
(a) Remove the front seat (Removal).
4. REMOVE FRONT SEAT ASSEMBLY (for Center Seat)
(a) Remove the front seat (Removal).

5. REMOVE FRONT DOOR SCUFF PLATE LH
(a) Detach the 6 claws and 3 clips, and remove the scuff plate.
6. REMOVE FRONT DOOR SCUFF PLATE RH

HINT: Use the same procedures described for the LH side.

7. REMOVE COWL SIDE TRIM BOARD LH
(a) Remove the clip.
(b) Detach the 2 clips and remove the cowl side trim board.
8. REMOVE COWL SIDE TRIM BOARD RH

HINT: Use the same procedures described for the LH side.

9. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
10. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

11. REMOVE UPPER BACK PANEL GARNISH
(a) Detach the 10 clips and remove the back panel garnish.

12. REMOVE LUGGAGE COMPARTMENT BOX LH
(a) Remove the 2 clips.
(b) Detach the 3 claws and remove the luggage compartment box.

13. REMOVE LUGGAGE COMPARTMENT BOX RH
(a) Remove the 4 clips and luggage compartment box.
14. REMOVE FRONT PILLAR GARNISH LH
(a) Using a screwdriver, detach the 2 claws and remove the 2 assist grip plugs.

HINT: Tape the screwdriver tip before use.

(b) Remove the 2 bolts and assist grip.
(c) Detach the claw and remove the front pillar garnish.

(d) Protect the curtain shield airbag.
(1) Thoroughly cover the airbag with a cloth or nylon sheet and fix the ends of the cover with adhesive tape, as shown in the illustration.

NOTE: Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.

15. REMOVE FRONT PILLAR GARNISH RH

HINT: Use the same procedures described for the LH side.

16. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH

(a) Detach the 2 claws and remove the cover.

(b) Remove the bolt and outer lap belt anchor.

(a) Detach the 2 claws and remove the cover.

(b) Remove the bolt and outer lap belt anchor.

(a) Using a screwdriver, detach the claw and remove the cover.

HINT: Tape the screwdriver tip before use.

(b) Detach the 2 claws and open the seat belt anchor cover.

(d) Remove the 2 bolts.
(e) Detach the 5 clips and remove the quarter trim panel.
19. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

HINT: Use the same procedures described for the LH side.

20. REMOVE ROOF CONSOLE BOX ASSEMBLY (Removal)

21. REMOVE VISOR BRACKET COVER LH
(a) Using a moulding remover, detach the 4 claws and remove the visor bracket cover.
22. REMOVE VISOR BRACKET COVER RH

HINT: Use the same procedures described for the LH side.

23. REMOVE VISOR ASSEMBLY LH
(a) Remove the 3 screws and visor.
24. REMOVE VISOR ASSEMBLY RH

HINT: Use the same procedures described for the LH side.

25. REMOVE VISOR HOLDER
(a) Remove the screw and visor holder.

HINT: Use the same procedure to remove the visor holder on the other side.

26. REMOVE ASSIST GRIP SUB-ASSEMBLY
(a) Using a screwdriver, detach the 4 claws and remove the 2 assist grip covers.

HINT: Tape the screwdriver tip before use.

(b) Detach the 2 clips and remove the assist grip.

27. REMOVE ASSIST GRIP PLUG
(a) Insert a screwdriver into the service notch and break off the cap.
(b) Detach the clip and remove the assist grip plug.

28. REMOVE COAT HOOK
(a) Using a screwdriver, detach the 2 claws and remove the coat hook cap.

HINT: Tape the screwdriver tip before use.

(b) Remove the screw and coat hook.
29. REMOVE ROOF HEADLINING ASSEMBLY
(a) w/ EC Mirror:

(1) Detach the 2 claws and remove the inner rear view mirror cover.

(2) Disconnect the EC mirror connector.

(b) Disconnect the roof wire connector and detach each clamp from the front pillar.

(d) Take out the roof headlining from the cabin as shown in the illustration.

NOTE: Be careful not to damage the roof headlining when taking it out.