On-Vehicle Inspection

2UZ-FE FUEL INJECTOR:

ON-VEHICLE INSPECTION

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
- Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY (Removal)

3. REMOVE AIR CLEANER HOSE ASSEMBLY (Removal)

4. INSPECT FUEL INJECTOR ASSEMBLY





(a) Disconnect the 8 injector connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:





If the resistance is not as specified, replace the injector.
(c) Reconnect the 8 injector connectors.
5. INSTALL AIR CLEANER HOSE ASSEMBLY (Installation)

6. INSTALL THROTTLE BODY COVER SUB-ASSEMBLY (Installation)

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).