Installation

3UR-FE LUBRICATION: OIL PRESSURE SWITCH:

INSTALLATION

1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY





(a) Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent





(b) Install the oil pressure sender gauge.
Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)

NOTE: Do not start the engine within 1 hour after installation.





(c) Connect the sender gauge connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).

3. INSPECT ENGINE OIL LEVEL (Testing and Inspection)

4. INSPECT FOR OIL LEAK (Replacement)

5. INSTALL NO. 1 ENGINE UNDER COVER (Replacement)