B2784
ENGINE IMMOBILISER: ENGINE IMMOBILISER SYSTEM: B2784: Antenna Coil Open / Short
DTC B2784 - Antenna Coil Open / Short
DESCRIPTION
The transponder key coil is built into the transponder key amplifier and receives a key code signal from the transponder chip in the key. This signal is amplified by the amplifier, and output to the transponder key ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. READ VALUE USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to the ON position and turn the Techstream main switch on.
(c) Select Antenna Coil Status in the Data List and read the value displayed on the Techstream.
Immobiliser:
OK:
Normal (Antenna coil is normal) appears on the screen.
OK -- REPLACE TRANSPONDER KEY ECU ASSEMBLY
NG -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - TRANSPONDER KEY AMPLIFIER)
(a) Disconnect the T8 ECU and I17 amplifier connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. INSPECT TRANSPONDER KEY ECU ASSEMBLY
(a) Reconnect the T8 ECU and I17 amplifier connectors.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK -- REPLACE TRANSPONDER KEY AMPLIFIER