DTC 5C-40

NAVIGATION: NAVIGATION SYSTEM: 5C-40: Camera Picture Error

DTC 5C-40 - Camera Picture Error

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - TELEVISION CAMERA ASSEMBLY)
(a) Disconnect the R26 connector from the radio and navigation assembly.
(b) Disconnect the T11 connector from the television camera assembly.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. INSPECT RADIO AND NAVIGATION ASSEMBLY
(a) Reconnect the radio and navigation assembly connector.

(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:

NG -- REPLACE RADIO AND NAVIGATION ASSEMBLY
OK -- Continue to next step.

3. INSPECT TELEVISION CAMERA ASSEMBLY
(a) Reconnect the radio and navigation assembly R26 connector and the television camera assembly T11 connector.

(b) Check the waveform of the television camera assembly using an oscilloscope.
(1) Measurement terminal: 3 - 4
Measurement setting: 0.2 V/DIV, 0.2 micro s/DIV
Condition: Ignition switch ON, Shift lever in R range
OK:
Pulses as shown in the illustration.

NG -- REPLACE TELEVISION CAMERA ASSEMBLY
OK -- REPLACE RADIO AND NAVIGATION ASSEMBLY