MIL Circuit
1GR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: MIL Circuit
MIL Circuit
DESCRIPTION
The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunction detections by the ECM.
By turning the ignition switch on, power is supplied to the MIL circuit, and the ECM provides the circuit ground, which illuminates the MIL.
The MIL operation can be checked visually: When the ignition switch is first turned on, the MIL should be illuminated and should then turn off. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the Techstream.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK THAT MIL IS ILLUMINATED
(a) Perform troubleshooting in accordance with the table below.
Result
B -- CHECK THAT MIL IS ILLUMINATED
A -- Continue to next step.
2. CHECK WHETHER MIL TURNS OFF
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch on.
(c) Turn the tester on.
(d) Check whether any DTCs have been stored DTC Check / Clear. Note them down if necessary.
(e) Clear the DTCs DTC Check / Clear.
(f) Check if the MIL turns off.
OK:
MIL should turn off.
OK -- REPAIR CIRCUIT INDICATED BY OUTPUT DTC
NG -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS)
(a) Disconnect the E7 ECM connector.
(b) Turn the ignition switch on.
(c) Check that the MIL is not illuminated.
OK:
MIL is not illuminated.
(d) Reconnect the ECM connector.
OK -- REPLACE ECM
NG -- CHECK AND REPLACE HARNESS AND CONNECTOR (COMBINATION METER - ECM)
4. CHECK THAT MIL IS ILLUMINATED
(a) Check if the MIL is illuminated when the ignition switch is turned on.
OK:
MIL should be illuminated.
OK -- SYSTEM OK
NG -- Continue to next step.
5. CHECK WHETHER ENGINE STARTS
(a) Turn the ignition switch on.
(b) Start the engine.
Result
B -- GO TO VC OUTPUT CIRCUIT
A -- Continue to next step.
6. INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT)
(a) See the combination meter troubleshooting procedure Meter / Gauge System.
NG -- REPAIR OR REPLACE BULB OR COMBINATION METER ASSEMBLY
OK -- CHECK AND REPLACE HARNESS AND CONNECTOR