Installation

EXTERIOR: FENDER LINER (for Front Side): INSTALLATION

INSTALLATION

1. INSTALL FRONT FENDER LINER LH





(a) Install the front fender liner LH with the 5 clips and 8 screws.





(b) Install 2 new grommets.
(c) Using a 4 mm hexagon wrench, install the 2 screws.





(d) Install the screw and pin hold clip.
Torque: 3.0 Nm (31 kgf-cm, 27 in-lbf)
2. INSTALL FRONT FENDER LINER RH





(a) Install the front fender liner RH with the 5 clips and 7 screws.





(b) Install 2 new grommets.
(c) Using a 4 mm hexagon wrench, install the 2 screws.





(d) Install the screw and pin hold clip.
Torque: 3.0 Nm (31 kgf-cm, 27 in-lbf)
3. INSTALL FRONT WHEEL OPENING EXTENSION PAD (for LH Side)





(a) Install the front wheel opening extension pad with the 2 screws.
4. INSTALL FRONT WHEEL OPENING EXTENSION PAD (for RH Side)
HINT: Use the same procedure for the RH side and LH side.

5. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH Installation
6. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY RH
HINT: Use the same procedures for the RH side and LH side.

7. INSTALL NO. 1 ENGINE UNDER COVER
8. INSTALL ENGINE UNDER COVER ASSEMBLY (for 2GR-FE) Installation