Component Tests and General Diagnostics

LIGHTING: HAZARD WARNING SWITCH: INSPECTION

INSPECTION

1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (w/o Navigation System)





(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:





If the result is not as specified, replace the integration control and panel assembly.
(b) Connect the (+) lead from the battery to terminal 6 and the (-) lead to terminal 7.
(c) Check that the illumination of the switch comes on.
OK:
The illumination comes on.
If the result is not as specified, replace the integration control and panel assembly.
2. INSPECT NAVIGATION RECEIVER ASSEMBLY (w/ Navigation System)





(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:





If the result is not as specified, replace the navigation receiver assembly.
(b) Connect the (+) lead from the battery to terminal 6 and the (-) lead to terminal 7.
(c) Check that the illumination of the switch comes on.
OK:
The illumination comes on.
If the result is not as specified, replace the navigation receiver assembly.