Vehicle Stability Control System

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: DIAGNOSTIC TROUBLE CODE CHART

DIAGNOSTIC TROUBLE CODE CHART

NOTE: When removing any parts, turn the ignition switch off.

HINT:
- If no abnormality is found when inspecting parts, check the skid control ECU and check for poor contact at ground points.
- If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the below table.
- When 2 or more DTCs are detected, perform each circuit inspection until the problem is identified.
- All DTCs in the table below are detected in accordance with 1 trip detection logic.

1. DTC CHART OF ABS

DTC Chart of ABS

C0200/31 - C0278/11:

C1225/25 - C1300/62:

C1330/35 - C1333/38 / U0073/94:

HINT: *1: Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed.

1. 5GDrive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.

2. Clear the DTC(s).

DTC CHART OF VSC

DTC Chart of VSC