Television Display Power Source Circuit

AUDIO / VIDEO: REAR SEAT ENTERTAINMENT SYSTEM: Television Display Power Source Circuit

Television Display Power Source Circuit

DESCRIPTION

This is power source circuit of the television display assembly.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT FUSE (RAD NO. 1, ACC)

(a) Remove the ACC fuse from the main body ECU.
(b) Remove the RAD NO. 1 fuse from the engine room junction block.
(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

(d) Install the fuses.

NG -- REPLACE FUSE
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY AND BODY GROUND)

(a) Disconnect the U2 television display assembly connector.
(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

(d) Reconnect the television display assembly connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE