Removal

3UR-FE STARTING: STARTER: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE NO. 1 ENGINE UNDER COVER Replacement
3. REMOVE FRONT FENDER APRON SEAL RH Removal
4. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
(a) Remove the dipstick.
(b) Disconnect the wire harness clamp.

(c) Remove the bolt and dipstick guide.
(d) Remove the O-ring from the dipstick guide.
5. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal
6. REMOVE FRONT NO. 3 FLOOR HEAT INSULATOR Removal
7. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Removal
8. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH Removal
9. REMOVE STARTER COVER

(a) Remove the 3 bolts and starter cover.
10. REMOVE STARTER ASSEMBLY

(a) Disconnect the starter connector.
(b) Remove the nut and disconnect the starter wire.

(d) Remove the flywheel housing side cover.