Inner Rear View Mirror Power Source Circuit

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM: Inner Rear View Mirror Power Source Circuit

Inner Rear View Mirror Power Source Circuit

DESCRIPTION

This is the power source circuit of the inner rear view mirror assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT FUSE (IG1 NO. 2)




(a) Remove the IG1 NO. 2 fuse from the main body ECU.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





(c) Install the fuse.
NG -- REPLACE FUSE
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (INNER MIRROR - BATTERY AND BODY GROUND)




(a) Disconnect the I8 inner rear view mirror assembly connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:





(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





(d) Reconnect the inner rear view mirror assembly connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE