Security Lamp/Indicator: Testing and Inspection

THEFT DETERRENT: SECURITY INDICATOR LIGHT ASSEMBLY: INSPECTION

1. INSPECT SECURITY INDICATOR LIGHT

(a) Disconnect the D40 ECU connector, with the E19 indicator connector connected.





(b) Apply battery voltage from the wire harness back side between the terminals of the indicator, and check the lighting condition of the security indicator.

Standard:





NOTICE:
* If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not come on.
* Voltage of more than 12 V will damage the security indicator.
* If the voltage is too low, the security indicator will not come on.
(c) If the result is not as specified, replace the passenger belt and airbag indicator.