Bluetooth Handsfree Module Communication Error

AUDIO / VISUAL: AUDIO AND VISUAL SYSTEM: Bluetooth Handsfree Module Communication Error
- Bluetooth Handsfree Module Communication Error

INSPECTION PROCEDURE

PROCEDURE

1. IDENTIFY THE COMPONENT SHOWN BY SUB-CODE

(a) Enter the diagnostic mode.





(b) Press the preset switch "3" to change to "Detailed Information Mode".

(c) Identify the component shown by the sub-code.

HINT
* "P190" set by the radio receiver shown in the preceding illustration as an example.
* For details of the DTC display, refer to "DTC CHECK/CLEAR" Reading and Clearing Diagnostic Trouble Codes.

NEXT -- Continue to next step.

2. CHECK COMPONENT SHOWN BY SUB-CODE

(a) Select the component shown by sub-code.

HINT
The "Bluetooth" handsfree module is built into the radio receiver. If there is a problem between the "Bluetooth" handsfree module and radio receiver, replace the radio receiver.

Component Table:





B -- REPLACE RADIO RECEIVER
A -- Continue to next step.

3. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE

(a) Inspect the power source circuit of the component shown by the sub-code.

If the power source circuit is operating normally, proceed to the next step.

Component Table:





NEXT -- Continue to next step.

4. INSPECT RADIO RECEIVER

(a) Disconnect the radio receiver connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





HINT
*1: w/ Rear Seat Entertainment System

NG -- REPLACE RADIO RECEIVER
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR ("BLUETOOTH" HANDSFREE MODULE - COMPONENT SHOWN BY SUB-CODE)

HINT
* Start the check from the circuit that is near the component shown by the sub-code first.
* For details of the connectors, refer to "TERMINALS OF ECU" Pinout Values and Diagnostic Parameters.

(a) Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the "Bluetooth" handsfree module and the component shown by the sub-code.

(1) Disconnect all connectors between the "Bluetooth" handsfree module and the component shown by the sub-code.

(2) Check for an open or short in the AVC-LAN circuit between the "Bluetooth" handsfree module and the component shown by the sub-code.

OK:

There is no open or short circuit.





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. REPLACE COMPONENT SHOWN BY SUB-CODE

(a) Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

OK:

Same problem does not occur.

NG -- REPLACE RADIO RECEIVER (BUILT-IN "BLUETOOTH" HANDSFREE MODULE)

OK -- END