On-Vehicle inspection

METER: METER / GAUGE SYSTEM: ON-VEHICLE INSPECTION

1. INSPECT SPEEDOMETER

(a) Check the operation.

(1) Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.









NOTICE:
Tire wear as well as over or under inflation will cause errors.

(2) Check the deviation from the acceptable range of the speedometer indication.

Reference:

Less than 0.5 km/h (0.3 mph)

HINT
If the indication is not as specified, go to problem symptoms table Problem Symptoms Table

2. INSPECT TACHOMETER

(a) Connect a tune-up tachometer, and start the engine.

(b) Compare the test results with the tachometer indications.






HINT
If the indication is not as specified, go to the problem symptoms table Problem Symptoms Table