Removal

DOOR LOCK: UNLOCK WARNING SWITCH: REMOVAL

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column Service Precautions

1. PRECAUTION

Steering System

2. POSITION FRONT WHEELS STRAIGHT AHEAD

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization

4. REMOVE FRONT WHEEL LH

5. REMOVE LOWER NO. 3 STEERING WHEEL COVER Removal

6. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal

7. REMOVE STEERING PAD Removal

8. REMOVE STEERING WHEEL ASSEMBLY Removal

9. REMOVE FRONT DOOR SCUFF PLATE LH Removal

10. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal

11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System) Removal

12. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System) Removal

13. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY Removal

14. REMOVE BRAKE PEDAL RETURN SPRING Removal

15. REMOVE STOP LIGHT SWITCH ASSEMBLY Removal

16. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS Removal

17. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY Removal

18. REMOVE STEERING COLUMN COVER Removal

19. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE Removal

20. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY Removal

21. SEPARATE STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY Removal

22. REMOVE STEERING COLUMN ASSEMBLY Removal

23. REMOVE STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY Removal

24. REMOVE KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System) Disassembly

25. REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System) Disassembly

26. REMOVE STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY Disassembly

27. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY Disassembly

28. REMOVE UN-LOCK WARNING SWITCH ASSEMBLY

(a) Remove the un-lock warning switch assembly by pushing up the center part and releasing the 2 claws.