Security Indicator Light Circuit

THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM (w/o Smart Key System): Security Indicator Light Circuit
- Security Indicator Light Circuit

DESCRIPTION

* When the engine immobiliser system is set, the security indicator light blinks continuously, but does not illuminate if the engine immobiliser system is not set.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
When the transponder key ECU assembly is replaced, refer to Registration Engine Immobiliser System (W/O Smart Key System).

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY INDICATOR LIGHT)

(a) Check that the security indicator light illuminates when operating it with the Active Test Engine Immobiliser System (w/o Smart Key System).

Immobiliser





OK:

Security indicator light can be turned on and off using the Techstream.

NG -- INSPECT TELLTALE LIGHT ASSEMBLY (SECURITY INDICATOR LIGHT)

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Engine Immobiliser System (w/o Smart Key System)

2. INSPECT TELLTALE LIGHT ASSEMBLY (SECURITY INDICATOR LIGHT)

(a) Remove the telltale light assembly Removal.





(b) Apply battery voltage between the terminals of the telltale light assembly and check that the security indicator light illuminates.

OK:





NG -- REPLACE TELLTALE LIGHT ASSEMBLY Removal
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (TELLTALE LIGHT - TRANSPONDER KEY ECU AND BODY GROUND)

(a) Disconnect the F32 light connector.

(b) Disconnect the F34 ECU connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE TRANSPONDER KEY ECU ASSEMBLY Removal